Study of Compressive Strength of Concrete by Partial Replacement of Cement with Marble Dust Powder Abdullah Anwar, Juned Ahmad, Meraj Ahmad Khan, Sabih Ahmad, Syed Aqeel Ahmad DOI No: 10.1453/IJMER/75
1-4
2
Review Paper: Optimization (MCDM) Tools Used in Selection Process Bolade R.S., Katkar M. M., Gandhare B. S., Lawand S. S. DOI No: 10.1453/IJMER/76
5-9
3
Tensile and wear behaviour of Al-4.5%Cu alloy reinforced fly ash/SiC by stir and squeeze casting with rolled composites G.N.Lokesh, M.Ramachandra, K.V.Mahendra DOI No: 10.1453/IJMER/77
10-15
4
Design and Analysis of Gear Tooth for Engine Gear Train to Avoid Failure due to Bending and Pitting by Varying CR Tushar K. Rasane, Vishavjit L. Bhanavase DOI No: 10.1453/IJMER/79
16-22
5
Evaluation of patch repaired composite panel under tensile loads Vijayakumar Pujar, Vijaya B, M Mohan Kumar DOI No: 10.1453/IJMER/83
23-26
6
Development of Fuel Injection System for Different Fuel Injection Timing Hardik A Dave, Shrikruishna P. Chincholkar DOI No: 10.1453/IJMER/84
27-29
7
Review on Effect of Exhaust Gas Recirculation (EGR) on Performance and Emission of Diesel Engine Shivaji Barwe, Y. R. Suple DOI No: 10.1453/IJMER/85
30-37
8
Control system for Robotic Arms over Controller Area Network (CRACAN) Anu Jose, Shinu M R, Gana Rani Jose DOI No: 10.1453/IJMER/86
38-43
9
Experimental Studies on Hydrodynamic Behavior of an Air Lift Loop G.K.Pujari, N.M.Rao, Avssk Gupta, Mallikarjuna B.B DOI No: 10.1453/IJMER/87
44-47
10
Benefit-Function of Two- Identical Cold Standby System subject to Failure due to buckling or sun kink caused by high compressive stress Ashok Kumar Saini DOI No: 10.1453/IJMER/101